Hagie 204, Operator'S Manual

Page: 112 / 141

Start the nuts on the mounting bolts and
tighten them until they are just snug. Following
the torque sequence in figure 7.65, turn each lug
nut to a torque value of 100 dry foot-pounds. Use
slow, even pressure on the torque wrench. Quick
or jerky movements cause inaccurate values.
Lower the detasseler to the ground and
repeat the same sequence to 130 dry foot-
pounds and again finally to 160 dry foot-pounds.
Resume operation and recheck torque
values after 30 minutes of operation.
x
VII. SERVICE AND MAINTENANCE
Leg Mounting Bolts
BOLT TORQUE CONTINUED
Follow these procedures for torquing the leg
mounting bolts:
Never remove more than three leg
mounting bolts from any single leg
FIG 7.64
NOTE:
See page XX for additional infor-
mation regarding leg mounting
FIG 7.65
1
2
4
3
5
6