GSSI SIR 30, Manual

Page: 20 / 150

Geophysical Survey Systems, Inc. SIR® 30
Manual
MN 93-101 Rev E 14
Step 6: Restart and Test
1
Restart the Client PC.
2
Restart the SIR 30.
3
Wait for both systems to boot.
4
Select either the English or Metric the SIR 30 user interface on the Client PC.
5
If the installation\configuration has failed at some step in the above procedure, the computer will
display a “Cannot find SIR 30 Sever” message and the user interface will not start. Please follow the
steps below to trouble shoot the system.
Troubleshooting SIR 30 Client Computer Connectivity Issues
If the User is experiencing connectivity problems between the SIR 30 and client, the User should first
check that the Ethernet cable is connected and that the cable is a straight connect cable.
Re-cycle the power on both the laptop and SIR 30 and wait for them to boo. Please wait 10 seconds after
pushing the button for the SIR 30 to start. You will hear a Windows start tone once the SIR 30 is has
booted up.
Requirements for Connectivity
•
A SIR 30 \Laptop-Client connection.
•
The Server Computer Name: SIR 30-SNXXX \YYY where XXX\YYY is the last 3 digits of the
control unit serial number.
•
User Name: SIR 30_Admin
•
Password: SIR
•
The SIR4xSvr DCOM settings must match those detailed above.
•
Firewall settings that have been configured by the Maintenance Tool.
•
The SIR 30 C: drive RADARDATA directory sharing set to Read/Write for Everyone.
•
Straight connect Ethernet cable to connect SIR 30 and Client computer. If the User has the SIR 30
connected to a network, check to make sure that it works with a direct connection before contacting
GSSI.
Note:
If you are running the SIR 30 through a switch, the User will need to troubleshoot any switch
connectivity issues with your IT department.
•
A Client Computer that has been successfully configured using the SIR 30 maintenance tool as
described in the previous section.
•
SIR 30 UI and Server with SIR 30 Firewall settings configured by the Maintenance Tool.
If you are still having trouble, please test the following before contacting GSSI:
•
Verify that the SIR 30 is running.
•
Verify that the Client computer is running.