GSSI SIR 30, Manual

Page: 130 / 150

Geophysical Survey Systems, Inc. SIR® 30
Manual
MN 93-101 Rev E 124
8
From the Software/Firmware Tab on the SIR 30 Maintenance Utility click the button Prep System for
Firmware Updates. The SIR 30 UI will open to the System Settings Screen.
9
Select Versions at the bottom right of the screen. Write down the following information for RADAR1
if you have a 2channel system or RADAR1 and RADAR2 if you have a 4 channel system.
10
Compare these versions to the versions listed in the SIR 30 Release Notes. It is not necessary to
change the version of the boot loader.
11
The firmware must be installed to both RADAR boards in a SIR 30. These instructions target DSP
Firmware, GPR Control, and GPR Antenna software. Only install them if they have different version
numbers than the versions in the SIR 30Versions.pdf file.
Part 1: Installing DSP Firmware
(if version number does not match new version)
a)
Under RADAR1:
Select DSP Firmware and click Upgrade (takes about 5 seconds).
Under RADAR2:
Select DSP Firmware and click Upgrade (takes about 5 seconds).
Part 2: Installing GPR Control
(if version number does not match new version)
a)
Under RADAR1:
Select GPR Control and click Upgrade (takes about 5 seconds wait till it
finishes beeping).
Under RADAR2:
Select GPR Control and click Upgrade (takes about 5 seconds wait until it finishes
beeping).
Part 3: Installing GPR Antenna
(if version number does not match new version)
a)
Under RADAR1:
Select GPR Antenna and click Upgrade (takes about 45 seconds wait till it
finishes beeping).
Under RADAR2:
Select GPR Antenna and click Upgrade (takes about 45 seconds wait until it
finishes beeping).