r3a-x2.0
3
Introduction
With your
r-THREE
system, you will be able to easily setup and
remotely control up to three cameras.
The key elements of the
r-THREE
system are:
From a single point (your chair) and a single controller
(in your hands), you have the ability to
o
dynamically switch to any camera and operate the
camera remotely (e.g. start/stop record, zoom, focus,
exposure, pan & tilt, etc).
o
monitor the view for all camera.
o
attach the composite video signal from two or all
three cameras to a live switch or purchase the
LS
option.
o
monitor the status of your cameras (e.g. record
on/off, time codes, battery charge, etc).
o
configure the system to your needs (e.g. adjust pan,
tilt and zoom speed, configure joystick response, etc.)
o
send camera menu commands to your LANC camera
as if you were dialing the menus dial from the back
of your camera. (e.g. exposure control)
In addition, only a very thin, flexible CAT5 cable from each
pan/tilt head to one centralized interface box is needed for
each remote camera. This cable powers the pan/tilt head
and enables the remote control features for the associated
pan/tilt head and camera as well as sending a video feed
back to the operator. Except for the cameras, the power for
the entire system comes from this one centralized point in
the
r-THREE
system.
