r3a-x2.0
19
Blinking green – camera is powered on but not
recording.
Solid green – camera is powered on and recording.
Blinking red – record protect tab is set, or power is
low, or less than 5 minutes of tape remains, or
there is no tape in the camera.
TILT or PAN LIMIT Lights
No light – you can continue to pan or tilt as you
have not yet reached the limit of the Pan/Tilt
head.
Flashing amber – you have reached the pan or tilt
limit of the Pan/Tilt head and thus you can go no
further in that direction.
PWR Button
Power on/off the current Preview Camera by
pressing PWR. This assumes that the selector switch
on the physical camera has been previously set to
CAMERA.
If you press and hold the PWR button for greater than
2 seconds, all cameras will power on simultaneously.
But, when powering off, each camera must be
powered off separately - as described in the above
paragraph.
MODE Button
The MODE Button indicates if you are in SYS MODE,
CAM MODE or neither (aka Time Code Mode). By
pressing the MODE button you will cycle through
these modes.
Press the MODE button :
1.
once and you will be in SYS MODE and the
SYS MODE Light will be on.
