User Manual for Vital Signs Monitor
8
3.2 Installation
3.2.1 Opening the Package and Check
1. Open the package, take out the monitor accessories from the box carefully and place it in a safe
stable and easy to watch position.
2. Open the accompanying document to sort the accessories according to the packing list.
Inspect the monitor for any mechanical damages
Check all the accessories for any scratch or deformity, especially on connector, wire and probe
parts
☞
You can customize the module configuration by choosing necessary modules to meet your own
needs. Therefore, your monitor may not have all the monitoring functions and accessories.
If in doubt, please contact the local dealer or our company in case of any problems. We are to offer
you the best solution for your satisfaction.
3.2.2 Connecting the Power Supply
1. When powered by AC mains power supply:
Make sure that the AC power supply is 100-240VAC, 50/60Hz.
Use the power cable prepared by the manufacturer. Insert one end of it to the power port of
the monitor and the other end to the grounded three-phase power jack.
To eliminate potential differences, the monitor has a separate connection to the equipotential
grounding system. Connect one end of the provided ground cable to equipotential grounding
port on the rear of the monitor, and connect the other end to one point of the equipotential
grounding system.
Caution: ensure that the monitor is grounded correctly.
After the supply mains has been interrupted when power switch remains in the “on” position and is
restored after a period of time that is longer than 30 seconds, the monitor will run by the last
settings when restarting the monitor.
2. When powered by built-in battery
Caution: it’s better to recharge the battery after it is used up, the charging time should be
13~15 hours long.
The provided battery of the monitor must be recharged after transportation or storage. So if
the monitor is switch on without being connected to the AC power socket, it may not work
properly due to insufficient power supply.
3.2.3 Starting the Monitor
The system performs self-test and enters initial display after switching on the monitor, and the orange alarm
indicator blinks to inform that the user can begin operating it.
Check all the applicable functions to make sure that the monitor works normally.
If the battery is applied please recharge it after using the monitor to ensure sufficient power
storage. It will take minimal 8 hours to charge battery from depletion to 90% charge.
