User Manual for Vital Signs Monitor
6
15 Alarm silence indicator:
When it is on, it indicates that the monitor stays in alarm silence status.
16
Print:
the internal printer is optional, press this key to print the current measuring data;
17
S
Up: shift cursor forward/upward
18
▇
OK: to confirm selection or modification
19
T
Down: shift cursor backward/downward
20
Display: short time pressing to shift LCD display modes; longtime pressing to enter into Setup
Menu display screen.
21
7
Waveform Freeze: freeze the current displayed waveform.
22
ECG Lead Selection: select ECG leads among I, II, III, aVR, aVL, aVF and V.
23
～
:
AC Power indicator
24
:
DC Power indicator
AC Power indicator DC Power indicator
Descriptions
Status
ON (green)
ON (green)
this device is using mains power supply
ON (green)
ON (orange)
this device is using mains power supply and
the battery is being recharged.
OFF
ON (green)
the battery is being used
OFF
ON (orange, blinking)
the battery is being used, but battery voltage
is low, the beeper also gives warning.
ON (green)
OFF
the battery is being recharged while the
device is off
25
:
Power button: Press power button for 3 seconds to start the monitor or shut off the monitor.
Note:
Short time pressing power button for entering the Power Saving Mode screen, then according to
your need to make the device stay in the power saving mode or exit from power saving mode (this
function is optional and needs hardware support).
26 SpO
2
:
SpO
2
sensor connector
27 NIBP:
NIBP hose connector
28 TEMP:
TEMP probe connector
29 ECG:
ECG cable connector
3.1.2 Side Panel
The built-in thermal printer is in the left panel. It is easy for user to print waveform and data.
