Start-up
Configuring Network with DCM2.1 (with SSoM) and Later Hardware
Page 3-10 MDE-4902E Encore® 700 S Start-up and Service Manual · February 2018
Setting CRIND Side B IP
Note: Set CRIND Side B IP option is not visible on single side units.
From the Set IP Addresses menu, press
2
>
Enter
. The CRIND Side B IP screen is displayed.
Note: Side B will correspond with the side opposite of where you are standing.
Figure 3-11: CRIND Side B IP (example without SSoM)
CRIND Side B IP
000 . 000 . 000 . 000
Enter number blocks using three digits each with
leading zeros if necessary.
IP block range: 000 – 255
Example: 010 . 005 . 055 . 072
Clear = Erase Entry
Enter = Save Value and Exit
Cancel = Discard Changes and Exit
To set Side B IP address, number block must be in the 000-255 range and has to be completed
with leading zeros as follows:
• Press
Clear
to erase all entered digits and start again.
• Press
Enter
to validate if it is a correct IP address and to store the result. If the IP address
is not valid, the input is cleared.
• Press
Cancel
to discard the input and return to Set IP Addresses menu.
Setting SMART Merchandising Server IP
From the Set IP Addresses menu, press
4
>
Enter
. The SMART Merchandising IP screen is
displayed.
Note: The default value for SMART Merchandising Server, Netmask, and Gateway will work
for most sites.
Figure 3-12: SMART Merchandising IP
SMART Merchandising IP
000 . 000 . 000 . 000
Enter number blocks using three digits
each with leading zeros if necessary.
IP block range: 000 – 255
Example: 010 . 005 . 055 . 066
Clear = Erase Entry
Enter = Save Value and Exit
Cancel = Discard Changes and Exit
