Activating Encore 700 S CRIND
Configuring/Activating Encore 700 S CRIND
Page 5-6 MDE-4902E Encore® 700 S Start-up and Service Manual · February 2018
8
Press
1
>
Enter
to activate the unit. The message, “ALL DISMOUNTING SENSORS
ENABLED UNIT ACTIVATED” is displayed.
Figure 5-9: Activation Screen
9
Perform one of the following:
• Press
OK
to exit the menu.
• Press
CANCEL
to restart the Encore 700 S CRIND device.
Activation will enable all the connected secure modules.
Note: It is not possible to enable only one component and retain the other components in an
inactive state.
Contrary to activation, the de-activation procedure does not require keypad entries. Therefore,
no options are available in the menu. When the system sensors detect that a module with
mounting sensors is dismounted, it automatically self-deactivates. The activation procedure
must be repeated.
At each power up, if the Encore 700 S CRIND main processor detects a module that is not
activated, it will automatically enter the Service Menu (green screen). For a description of the
various diagnostics screens, refer to
“Appendix A: Diagnostic Screens”
on
