Start-up
Configuring Network with DCM2.1 (with SSoM) and Later Hardware
Page 3-6 MDE-4902E Encore® 700 S Start-up and Service Manual · February 2018
Configuring Network with DCM2.1 (with SSoM) and Later
Hardware
CRIND side IP addresses must not be changed from factory default unless one of the
following three conditions apply:
1) The site requires a non-standard IP scheme.
2) The site is configured for non-standard CRIND IDs.
3) Some third-party POS systems start with “0” instead of “1” as their first CRIND ID.
For example, dispenser 1 is configured for CRIND IDs 1/4 instead of 1/2.
WARNING
WARNING
!
Note: The CRIND device on each side is independent of the CRIND device on the other side.
Each side must be programmed individually.
From the Main Menu, press
3
>
Enter
. The Network Config menu is displayed.
Figure 3-7: Network Config Menu
Network Config
1. Reset to Default IPs
2. Set IP Addresses
3. Apply Network Settings
4. View Network Settings
5. Hide Network Settings
Cancel = Exit
