MDE-4902E Encore® 700 S Start-up and Service Manual · February 2018
Page 3-15
Adjusting Audio Volume Level
Start-up
Adjusting Audio Volume Level
Adjust the audio volume level on both sides of the unit individually.
IMPORTANT INFORMATION
The audio must be set for all Encore 700 S CRIND units. Audio is used for Applause Media
System functionality and for log collection for engineering troubleshooting purposes. Log
collect utilizes audio prompting instructions. Gilbarco recommends a starting value of “90” to
test the audio level. The value can be adjusted depending on the ambient noise level of the
forecourt.
To adjust the audio volume level, proceed as follows:
1
Press
1
>
Enter
for the Main Menu.
2
Press
2
>
Enter
for device configuration.
3
Press
2
>
Enter
for audio settings.
4
Press
1
>
Enter
for side 1.
Figure 3-20: Volume-Side 1
Volume—Side 1
20
Volume (Range: 1 - 99) Test>
Number Keys = Direct Entry
Clear = Erase Entry Up>
Enter = Apply Entry
Cancel = Exit Down>
5
Set the audio volume level by either entering the required number or using the up or down
softkey functions.
Note: It is recommended that you set the audio volume based on the ambient noise at the site.
6
Press
Enter
to save the settings.
7
Press
Cancel
to end the session.
