Service
FlexPay Control Board [FCB (M11930K001)]
Page 4-18 MDE-4902E Encore® 700 S Start-up and Service Manual · February 2018
The following table lists the LED/jumper and their functions:
LED/Jumper
Function
ECR
The Encrypted Card Reader (ECR) LEDs are active and indicate communication to
SCR/ECR.
Pump/PRN
The Pump/PRN LEDs indicate communication to the pump node. In Generic Mode,
the Pump/PRN LEDs stay in a steady-state (either OFF or ON) and do not blink.
The Pump/PRN LEDs continuously blink in MOC mode, after the CRIND device
comes up completely.
EPP
The EPP LEDs are active and indicate communication to FlexPay EPP.
POS/OTI
The POS/OTI LEDs are active and indicate communication to POS through HIP.
Lost Key
The Lost Key LEDs are “ON”, if the secure key is lost (requires FlexPay CRIND
Control Board replacement). Else, the Lost Key LEDs are “OFF”.
Secure ACT
The Secure ACT LEDs are blinking (normal), blinks at a constant rate.
OMAP ACT
The OMAP ACT LEDs are blinking (normal). However, these LEDs may not blink at
a constant rate.
Recovery Jumper
These jumpers may be used for recovery in some cases when a unit fails
catastrophically.
Note: This is a Gilbarco led event. Do not use unless instructed by Gilbarco.
