Gestetner B147, Service Manual

Page: 826 / 1081

BIT SWITCHES
B603 32 SM
Width and
reduction A4: A4 (8.3"), no reduction
B4: B4 (10.1"), no reduction
A3: A3 (11.7"), no reduction
I/O rate 0: 0 ms/line 10: 10 ms/line
25: 2.5 ms/line 20: 20 ms/line
5: 5 ms/line 40: 40 ms/line
Note:
“40” is displayed while receiving a fax message using AI short
protocol.
System Switch 01 - Not used (Do not change the factory settings.)
System Switch 02 SP No. 1-101-003
No FUNCTION COMMENTS
0
to
1
Not used Do not change the setting.
2 Communication error reset 0: OFF/1: ON
Bit 2 turns on or off the communication error reset
switch. When this switch is on, the system forcefully
terminates the job under the following conditions:
1. A communication job has started, and
2. The job does not end within an hour.
After terminating the job, the system goes back to
the ready status. When this switch is on, the system
can automatically recover from a communication
error. You cannot adjust the timer for the second
condition above.
3 Not used Do not change the setting.
4 File retention time
0: Depends on User Parameter
24 [18(H)]
1: No limit
1: A file that had a communication error will not be
erased unless the communication is successful.
5 Not used Do not change the setting.
6
to
7
Memory read/write by RDS
Bit 7 6 Setting
0 0 Always disabled
0 1 User selectable
1 0 User selectable
1 1 Always enabled
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are locked out,
but the user can temporarily switch RDS on to allow
RDS operations to take place. RDS will
automatically be locked out again after a certain
time, which is stored in System Switch 03. Note that
if an RDS operation takes place, RDS will not switch
off until this time limit has expired.
(1,1): At any time, an RDS system can access the
machine.