Gestetner B147, Service Manual

Page: 873 / 1081

NCU PARAMETERS
SM 79 B603
Fax Op
tion
B60
3
Address Function Unit Remarks
680576 Number of rings until a call is
detected 1 Function 06-2 (parameter
06).
The setting must not be
zero.
680577 Minimum required length of the first
ring 20 ms See Note 4.
Function 06-2 (parameter
07).
680578 Minimum required length of the
second and subsequent rings 20 ms Function 06-2 (parameter
06-2).
680579 Ringing signal detection reset time
(LOW) Function 06-2 (parameter
09).
68057A Ringing signal detection reset time
(HIGH)
20 ms
Function 06-2 (parameter
10).
68057B
to
680580
Not used Do not change the
settings.
680581 Interval between dialing the last digit
and switching the Oh relay over to
the external telephone when dialing
from the operation panel in handset
mode. 20 ms Factory setting: 500 ms
680582 Bits 0 and 1 - Handset off-hook detection time
Bit 1 0 Setting
0 0 200 ms
0 1 800 ms
Other Not used
Bits 2 and 3 - Handset on-hook detection time
Bit 3 2 Setting
0 0 200 ms
0 1 800 ms
Other Not used
Bits 4 to 7 - Not used
680583
to
6805A0
Not used Do not change the
settings.
6805A1 Acceptable CED detection frequency
upper limit (high byte)
6805A2 Acceptable CED detection frequency
upper limit (low byte)
BCD (Hz) If both addresses contain
FF(H), tone detection is
disabled.
6805A3 Acceptable CED detection frequency
lower limit (high byte)
6805A4 Acceptable CED detection frequency
lower limit (low byte)
BCD (Hz) If both addresses contain
FF(H), tone detection is
disabled.
6805A5 CED detection time 20 ms
±
20 ms
Factory setting: 200 ms
6805A6 Acceptable CNG detection frequency
upper limit (high byte)
6805A7 Acceptable CNG detection frequency
upper limit (low byte)
BCD (Hz) If both addresses contain
FF(H), tone detection is
disabled.