Gestetner B147, Service Manual

Page: 333 / 1081

COPY SERVICE MODE
SM 5-45 B147/B149/B190
Service
Tables
Jam Detection: Continuous
Count [02~10 / 5 / 1]
5-508-12*
Sets the number of consecutive paper jams required to initiate a call. This setting is
enabled only when SP5508 004 is set to 1.
Door Open: Time Length
[03~30 / 10 / 1] 5-508-13*
Sets the length of time the door remains open before the machine initiates a call.
This setting is enabled only when SP5508 004 is set to 1.
Jam Operation: Time Length
0: Automatic Call
1: Audible Warning at Machine
5-508-21*
Determines what happens when a paper jam is left unattended.
Jam Operation: Continuous
Count
0: Automatic Call
1: Audible Warning at Machine
5-508-22*
Determines what happens when consecutive paper jams occur.
Door Operation: Time Length
0: OFF, 1: ON 5-508-23*
Determines what happens if the door remains open (15 min.).
Displays a warning if set to ON. Pressing the call button will contact the service
center. This setting is available for setting only if SP5508 004 is set for 1.
5-610 [ACC Factory Setting]
Recall 5-610-4
Recalls the factory settings.
Overwrite
5-610-5
Overwrites the current values onto the factory settings.
Previous Setting
5-610-6
Recalls the previous settings.
[Toner Ratio in 2C] 5-611
Adjusts the color balance of a single color (blue, green, or red) by changing the
proportion of color toner (C, M, and/or Y).
5-611-1 B-C [ 0 to 100 / 90 / 1 %/step ]
5-611-2 B-M [ 0 to 100 / 80 / 1 %/step ]
5-611-3 G-C [ 0 to 100 / 90 / 1 %/step ]
5-611-4 G-Y [ 0 to 100 / 80 / 1 %/step ]
5-611-5 R-M [ 0 to 100 / 100 / 1 %/step ]
5-611-6 R-Y
*CTL
[ 0 to 100 / 80 / 1 %/step ]
5-801 [Memory Clear]
NOTE
: For more information, see “NOTE 1” following this table.
5-801-1 All Clear
Resets all correction data for process control and all software counters, and
returns all modes and adjustments to their default values.
To execute, hold down

for over 3 seconds, and then turn the copier off and
on again.
Use this SP only after replacing the NVRAM, or after the copier has
malfunctioned due to a damaged NVRAM.
5-801-2 ENG All
Initializes items 2 ~ 12 below.
5-801-3 SCS
Clears the system settings.
IMH Memory Clr 5-801-4
Clears IMH data. DFU