Gestetner B147, Service Manual

Page: 884 / 1081

SERVICE RAM ADDRESSES
B603 90 SM
6800D8(H) - User parameter switch 08 (SWUSR_08)
Bits 0 and 1: Not used.
Bit 2: Authorized reception
0: Only faxes from senders whose RTIs/CSIs are specified for this feature
are accepted.
1: Only faxes from senders whose RTIs/CSIs are not specified for this feature
are accepted.
Bits 3 to 7: Not used.
6800D9(H) - User parameter switch 09 (SWUSR_09) : Not used
6800DA(H) - User parameter switch 10 (SWUSR_0A)
Bit 0: Not used
Bit 1: 2 into 1 0: Off, 1: On
Bit 2: Not used
Bit 3: Page reduction 0: Off, 1: On
Bits 4 to 7: Not used
6800DB(H) - User parameter switch 11 (SWUSR_0B)
Bit 0: Not used
Bit 1: Method of transmitting numbers after the “Tone” mark over an ISDN line
0: UUI, 1: Tone
(Japan Only)
Bits 2 to 5: Not used
Bit 6: Printout of messages received while acting as a forwarding station
0: Off, 1: On
Bit 7: Polling Standby duration 0: Once, 1: No limit
6800DC(H) - User parameter switch 12 (SWUSR_0C) : Not used
6800DD(H) - User parameter switch 13 (SWUSR_0D) (Japan Only)
(This switch is not printed on the user parameter list.)
Bits 0 to 4: Not used
Bit 5: Action when receiving a SETUP signal containing no called number and the
G4 subscriber number was programmed in this machine.
0: Respond to the call, 1: Do not respond to the call
Bit 6: Action when the received HLC (Higher Level Capabilities) is Tel or BC
(Bearer Capabilities) is Speech.
0: Do not respond to the call, 1: Respond to the call
This switch determines which information transfer capabilities the machine can
accept when receiving a call.
1: When the received HLC is Tel (digital telephone) or BC is Speech (voice), the
machine responds to the call. In short, the machine receives every call.
This switch is useful for communication problems when the other terminal informs
the above transfer capabilities although it is a fax machine.
Bit 7: ISDN SPID programming (used only in the USA)