Gestetner A294, Service Manual

Page: 515 / 600

FIRMWARE HISTORY
SM 7-57 A294/A295
T
rouble
-
s
hooting
A294 / A295 FIRMWARE MODIFICATION HISTORY
No
.
Title DESCRIPTION OF MODIFICATION
SERIAL
NUMBER
SOFTWARE
VERSION
1 Default setting in
SP1902-4 (Web
Near End Setting)
(A294-II/A295-II
only) The default setting of SP1902-4 for the
new A294-II/A295-II models is 90% for
US and 86% for Europe/Asia.
2 300 dpi print from
document server
(out of
specifications) 600 dpi images are printed out from the
document server when 300 dpi images
are stored using the EFI controller and
PCL language.
The specification is that 300 dpi prints
are allowed in the direct print mode.
As a special solution, the software has
been changed to allow 300 dpi images
out from the document server. However,
there are limitations that abnormal
images appear when using stamps.
A2945609 A/
A2945269 A 8.3
3 Paper jam in 2nd
copy set with
duplex, 2-position
staple and rear
cover modes A paper jam occurs in the 2nd set of
copies when using the duplex, 2-
position staple and rear cover modes.
The jam location number is 62 (Relay
sensor (stay on)).
E.g. A jam occurs under the following
conditions:
!
Number of originals: 6 sheets
(A4/LT long edge feed)
!
Duplex: 1 side to 2 sides
!
Staple: 2 positions
!
Cover sheet: Back cover (blank)
•
Number of copies: 5 sets
NOTE: The default settings for display languages are as follows:
USA version: 1st: English (NA), 2nd: Spanish
European version: 1st:English (UK), 2nd: No selection
Updating the language Firmware is overwriting the 1st and 2nd language areas. Also, updating
the SICU & BCU firmware is overwriting the 1st and 2nd language areas with the default
language. When the different languages are selected from the default setting, the language
Firmware should be re-installed after updating SICU & BCU firmware.
⇒
Rev. 06/2002
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA