B. Gohl
©
GEOSAT
pro
40
Transponder (TP)
- A list of pre
programmed transponders is available
for each satellite. Press LEFT or
RIGHT NAV key or press List/OK
key to display scroll list. If the target
transponder is not displayed, go to
TP List 2.5 and add a transponder.
Note: An active transponder must be
selected for the target satellite, Failure
to select an active transponder will
result in no valid signal for locating
and identifying the satellite. You
may find a list of satellites and active
transponders at www.lyngsat.com.
LNB LO (Local Oscillation)
– A list
of typical LNBF LO frequencies is
available for each satellite. Press LEFT
or RIGHT NAV key or press List/OK
key to display scroll list. Select the
LO frequency that corresponds with
the LO Frequency printed on the
connected LNB or LNBF. Note: The
correct LNB LO must be selected for
the connected LNBF, Failure to select
the correct LNB LO frequency will
result in no valid signal for locating
and identifying the satellite.
DiSEqC 1.0
– Switch Setting. If
multiple satellite dishes or multiple
LNB(f)s are connected to your
receiver (up to 4 inputs), determine
if the switch type is DiSEqC 1.0. If
so, press LEFT or RIGHT NAV key
or press List/OK key to display scroll
list. Select the switch port that is
connected to the target satellite.
Failure to select a correct port if a
switch is inline will result in no valid
signal for locating and identifying the
satellite. The correct switch port must
be selected for the receiver to “see”
the connection to the LNBF.
