Geneko GWR High Speed Router Series, User Manual

Page: 88 / 133

User Manual
Geneko GWR High Speed Router Series
88
Scenario #1
Router 1 and Router 2 , presented in the Figure 64 , have firmware version that provides two modes of negotiation in
IPSec tunnel configuration process:
•
Aggressive,
•
Main,
In this scenario, aggressive mode will be used. Configurations for Router 1 and Router 2 are listed below.
The GWR-HS Router 1 configuration:
Click Network Tab, to open the LAN NETWORK screen. Use this screen to configure LAN TCP/IP settings.
Configure IP address and Netmask:
•
IP Address: 10.0.10.1,
•
Subnet Mask: 255.255.255.0,
•
Press Save to accept the changes.
Figure 72 – Network configuration page for GWR-HS Router 1
•
Use SIM card with a static IP address, obtained from Mobile Operator.
•
Click
WAN Settings
Tab to configure parameters necessary for GSM/UMTS connection. All parameters
necessary for connection configuration should be required from mobile operator.
•
Check the status of GSM/UMTS connection ( WAN Settings Tab). If disconnected please click Connect
button.
•
Click VPN Settings > IPSEC to configure IPSEC tunnel parameters. Click Add New Tunnel button to create
new IPSec tunnel. Tunnel parameters are:
•
Add New Tunnel
•
Tunnel Name: IPsec tunnel,
•
Enable: true,
•
Local Group Setup
•
Local Security Gateway Type: SIM card,
•
Local ID Type: IP Address,
•
IP Address From: SIM 1 (WAN connection is established over SIM 1),
•
Local Security Group Type: Subnet,
•
IP Address: 10.0.10.0,
•
Subnet Mask: 255.255.255.0.
•
Remote Group Setup
•
Remote Security Gateway Type: IP Only,
•
IP Address: 172.29.8.5,
•
Remote ID Type: IP Address,
•
Remote Security Group Type: IP,
•
IP Address: 192.168.10.1.
•
IPSec Setup
•
Key Exchange Mode: IKE with Preshared key,
•
Mode: aggressive,