Geneko GWR High Speed Router Series, User Manual

Page: 105 / 133

User Manual
Geneko GWR High Speed Router Series
105
•
show ip interface —Displays the IP address assignment to the spoke router.
•
show crypto isakmp sa detail —Displays the IKE SAs, which have been set–up between the IPsec
initiators.
•
show crypto ipsec sa —Displays the IPsec SAs, which have been set–up between the IPsec initiators.
•
debug crypto isakmp —Displays messages about Internet Key Exchange (IKE) events.
•
debug crypto ipsec —Displays IPsec events.
•
debug crypto engine —Displays crypto engine events.
IPSec Tunnel configuration between GWR-HS Router and Juniper SSG firewall
IPSec tunnel is a type of a VPN tunnels with a secure tunneling method. On the diagram below Figure 87 is
illustrated simple network with GWR-HS Router and Cisco Router. Idea is to create IPSec tunnel for LAN to LAN (site
to site) connectivity.
Figure 98 – IPSec tunnel between GWR-HS Router and Cisco Router
The GWR-HS Routers requirements:
•
Static IP WAN address for tunnel source and tunnel destination address,
•
Source tunnel address should have static WAN IP address,
•
Destination tunnel address should have static WAN IP address.
GSM/UMTS APN Type: For GSM/UMTS networks GWR-HS Router connections may require a Custom APN. A
Custom APN allows for various IP addressing options, particularly static IP addresses, which are needed for most
VPN connections. A custom APN should also support mobile terminated data that may be required in most site–to–
site VPNs.
The GWR-HS Router configuration:
•
Click Network Tab, to open the LAN NETWORK screen. Use this screen to configure LAN TCP/IP settings.
Configure IP address and Netmask.
•
IP Address: 192.168.10.1,
•
Subnet Mask: 255.255.255.0,
•
Press
Save
to accept the changes.