User Manual
Geneko GWR High Speed Router Series
81
•
Click
WAN Settings
Tab to configure parameters necessary for GSM/UMTS connection. All parameters
necessary for connection configuration should be required from mobile operator.
•
Check the status of GSM/UMTS connection (
WAN Settings
Tab). If disconnected please click
Connect
button.
•
Click
VPN Settings
>
GRE
to configure GRE tunnel parameters:
•
Enable: yes,
•
Local Tunnel Address: 10.10.10.1,
•
Local Tunnel Netmask: 255.255.255.252 (Unchangeable, always 255.255.255.252),
•
Tunnel Source: 10.251.49.2 (select HOST from drop down menu if you want to use host name as
peer identifier),
•
Tunnel Destination: 10.251.49.3 (select HOST from drop down menu if you want to use host name
as peer identifier),
•
KeepAlive enable: no,
•
Period:(none),
•
Retries:(none),
•
Press ADD to put GRE tunnel rule into GRE table.
•
Press
Save
to accept the changes.
Figure 62 – GRE configuration page for GWR-HS Router 1
•
Click
Routing
on
Settings
Tab to configure GRE Route. Parameters for this example are:
•
Destination Network: 192.168.2.0,
•
Netmask: 255.255.255.0,
•
Interface: gre_x.
Figure 63 – Routing configuration page for GWR-HS Router 1
•
Optionally configure IP Filtering and TCP service port settings to block any unwanted incoming traffic.
•
On the device connected on GWR-HS router 1 setup default gateway 192.168.4.1
The GWR-HS Router 2 configuration:
•
Click
Network
Tab, to open the
LAN NETWORK
screen. Use this screen to configure LAN TCP/IP settings.
Configure IP address and Netmask.
•
IP Address: 192.168.2.1,
•
Subnet Mask: 255.255.255.0,
•
Press
Save
to accept the changes.
Summary of Contents for GWR High Speed Router Series
Page 1: ...GWR High Speed Cellular Router Series User Manual version 1 1 Date June 2014...
Page 26: ...User Manual Geneko GWR High Speed Router Series 26 Figure 17 DHCP Server configuration page...
Page 61: ...User Manual Geneko GWR High Speed Router Series 61 Figure 38 Modbus gateway configuration page...
