Geneko GWG, User Manual

Page: 58 / 158

58
User Manual
GWG Gateway
certificate is in "CA Certificate" field.
Local Private Key Local peer’s private key.
Local / Remote Group Settings
Remote Host or IP
Adress
Enter a remote peer IP address or host name. This filed is available only in UDP
connect and TCP client model.
Redirect Gateway
Check this option in order to use tunnel interface for default route.
Tunnel Interface
Configuration
Options are: "Pull from server" and "Manual configuration". "Pull from server"
mode is used where remote peer is an OpenVPN server and where configuration
will be pulled. In "Manual configuration" mode, you can enter tunnel interface IP
addresses.
Manual configuration
Local Interface IP
Address
This is the IP address of the local VPN endpoint of local tunnel interface.
Remote Interface IP
Address
This is the IP address of the remote VPN endpoint of remote tunnel interface.
Network Topology
Configure virtual addressing topology. net30 - use a point-to-point topology, by
allocating one /30 subnet per client. p2p - use a point-to-point topology where
the remote endpoint of the client's tunnel interface always points to the local
endpoint of the server's tunnel interface. This mode allocates a single IP address
per connecting client. Only use when none of the connecting clients are Windows
systems. subnet - use a subnet rather than a point-to-point topology by
configuring the tunnel interface with a local IP address and subnet mask. This
mode allocates a single IP address per connecting client and works on Windows
as well.
Table 14 – OpenVPN parameters
Figure 29 – OpenVPN configuration page