Geneko GWG, User Manual

Page: 152 / 158

152
User Manual
GWG Gateway
- Destination address: Any
-
Packet state: NEW
- Policy: ACCEPT
After configuration is finished SAVE button should be selected and user is returned to main
configuration page. Priority of rule is changed by selecting number in drop-down menu. In this example
number 6 is selected.
6. WEB access is allowed from 212.62.38.210 IP address
In default firewall configuration rule for allowing WEB traffic is predefined (rule with priority 4, named
Allow HTTP on ppp_0 ) This rule can be used in example with additional restriction in source IP address to
212.62.38.210. Policy should be configured in following way:
- Enable: selected
-
Source address: Single IP; 212.62.38.210
- All other settings should remain the same like in the picture below
Figure
146
– Allowing WEB access
After configuration is finished SAVE button should be selected and user is returned to main
configuration page.
7. FTP traffic is allowed
New rule should be added by selecting ADD NEW RULE button. Policy should be configured in
following way:
- Rule name: Allow FTP
- Enable: selected
- Chain: INPUT
- Service: FTP
-
Protocol: TCP
- Port: 21
-
Input interface: ppp_0
- Source address: Any
-
Destination address: Any
- Packet state: NEW
-
Policy: ACCEPT
After configuration is finished SAVE button should be selected and user is returned to main
configuration page. Priority of rule is changed by selecting number in drop-down menu. In this example
number 8 is selected.