Geneko GWG, User Manual

Page: 123 / 158

123
User Manual
GWG Gateway
Figure
104
–LAN Port configuration page for GWG Gateway
•
Click Mobile Settings Tab to configure parameters necessary for GSM/UMTS/LTE connection. All
parameters necessary for connection configuration should be required from mobile operator.
•
Check the status of GSM/UMTS/LTE connection ( Mobile Settings Tab). If disconnected please click
Connect button.
•
Click VPN Settings > IPSEC to configure IPSEC tunnel parameters. Click Add New Tunnel button to
create new IPSec tunnel. Tunnel parameters are:
•
Add New Tunnel
• Tunnel Name: IPsec tunnel,
•
Enable: true.
•
Local Group Setup
• Local Security Gateway Type: SIM card,
• Local ID Type: IP Address,
• IP Address From: SIM 1 (WAN connection is established over SIM 1),
• Local Security Group Type: Subnet,
• IP Address: 192.168.10.0,
• Subnet Mask: 255.255.255.0.
•
Remote Group Setup
•
Remote Security Gateway Type: IP Only,
• IP Address: 150.160.170.1,
•
Remote ID Type: IP Address,
• Remote Security Group Type: Subnet,
• IP Address: 10.10.10.0,
• Subnet Mask: 255.255.255.0.
•
IPSec Setup
• Keying Mode: IKE with Preshared key,
•
Mode: aggressive,
• Phase 1 DH group: Group 2,
•
Phase 1 Encryption: 3DES,
• Phase 1 Authentication: SHA1,
•
Phase 1 SA Life Time: 28800,
• Phase 2 Encryption: 3DES,
•
Phase 2 Authentication: SHA1,
• Phase 2 SA Life Time: 3600,
• Preshared Key: 1234567890.
•
Failover
-
Enable Tunnel Failover: false.
•
Advanced
• Compress(Support IP Payload Compression Protocol(IPComp)): false,
•
Dead Peer Detection(DPD): false,
• NAT Traversal: true,
•
Send Initial Contact Notification: true.
Press Save to accept the changes.