Geneko GWG, User Manual

Page: 87 / 158

87
User Manual
GWG Gateway
Management – Command Line Interface
CLI ( Command line interface ) is a user text–only interface to a computer's operating system or an
application in which the user responds to a visual prompt by typing in a command on a specified line and
then receives a response back from the system.
In other words, it is a method of instructing a computer to perform a given task by "entering" a command.
The system waits for the user to conclude the submitting of the text command by pressing the
Enter or
Return key. A command–line interpreter then receives, parses, and executes the requested user command.
On router's Web interface, in Management menu, click on Command Line Interface tab to open the
Command Line Interface settings screen. Use this screen to configure CLI parameters Figure
61
– Command
Line Interface .
Command Line Interface
Label Description
CLI Settings
Enable telnet service
Enable or disable CLI via telnet service.
Enable ssh service Enable or disable CLI via ssh service.
View Mode Username Username for View mode.
View Mode Password Password for View mode
Confirm Password
Confirm password for View mode
View Mode Timeout
Inactivity timeout for CLI View mode in minutes. After timeout, session will auto
logout.
Admin Mode Timeout
Inactivity timeout for CLI Edit mode in seconds. Note that Username and
Password for Edit mode are the same as Web interface login parameters. After
timeout, session will auto logout.
Save Click Save to save your changes back to the GWG Gateway.
Reload Click Reload to discard any changes and reload previous settings.
Table 31 – Command Line Interface parameters
Figure 61 – Command Line Interface