5.4 Setting REPORT PARAMETER
The Starting Number of Reports
The starting number of full reports can be set for each of X1, X2, Z1 and Z2. Once it is set,
the number is increased by one each time a full report is printed out. For the starting
number, a maximum of four digits (0 to 9999) can be entered.
To set the starting number, move the cursor to the item you wish, enter the desired start-
ing number and press
ENTER
.
NRGT (Non Resettable grand Total)
The grand total can be pre-set in the memory of the cash register. If the grand total has to
be taken over from another cash register, or if the memory of cash register is initialized by
mistake, a grand total that has been written down can be entered. If you enter a grand
total, all future sales will be added to it.
To set NRGT, move the cursor to NRGT with
key, enter the amount (up to 12 digits
including decimals) and press
ENTER
.
To return to PROGRAM 2 MENU, just press
ESC
.
5.5 Setting STARTUP NUMBER
Setting PLU Maximum
The capacity is 6,000 PLU’s on this cash register. But according to the capacity of your
store or shop, PLU maximum can be set. Or you might waste roll paper whenever you
take reports.
To set PLU MAXIMUM, enter the number and press
ENTER
.
Setting Department Shift Number
The starting number of shifted departments (with
DEPT/SHFT
key) can be set. The last
department number is 40. Assume you set the number 11, the starting department num-
ber in the shifted level is 11. And successively, pressing
Department 2
after
DEPT/SHFT
key
means pressing
Department 12
.
To set the starting number of shifted department number, enter the number and press
ENTER
.
Setting Receipt Start Number
The receipt start number can be set. The factory default setting is 0001.
To set the receipt start number, move the cursor to RECEIPT START NO, enter the num-
ber (up to four digits) and press
ENTER
.
To return to PROGRAM 2 MENU, just press
ESC
.
5. P2 programming
43
1
2
3
4
5
6
7
8
9
10
11
12
