Instructions for use and maintenance
This manual is owned by GEA Niro Soavi Any reproduction, even partial, is prohibited.
07C100-7C0
GEA Niro Soavi
161
Instructions for assembly
For assembly, proceed as follows, referring again to Figure 7-28 as follows:
- fit the gasket
(5)
onto the rod of the pressure gauge (it is only for protection against dirt)
- insert the gasket
(2)
in its housing in the flange or in the head; it is recommended to use food-
grade Vaseline or a suitable lubricant to facilitate assembly operations
- fit the flange
(6)
on the body of the pressure gauge
(1)
and position the two half-rings
(4)
to hold
the flange in place
- insert the pressure gauge thus prepared in its housing and position the flange
(6)
on the studs
(8)
- screw on the nuts
(7)
by hand before fully tightening them.
Summary of Contents for Niro Soavi One7TS
Page 2: ......
