
GE
D
IRECTION
FQ091019, R
EVISION
2
V
IVID Q
N S
ERVICE
M
ANUAL
8-60
Section 8-3 - Internal Component Replacement Procedures
8-3-9-1
Tools
Use the appropriate Phillips and flat screw drivers, as indicated in the AUO LCD Flex Cable replacement
procedure.
8-3-9-2
Time Required
30 minutes
8-3-9-3
Preparation
Shut down the Vivid q N ultrasound unit, as described in
8-3-9-4
AUO LCD Cable and Flex Removal Procedure
NOTE:
The numbers shown in square brackets correspond to the numbers listed in
.
1.) Remove the AUO LCD display - refer to the
"AUO LCD Display Removal Procedure" on page 8-55
.
2.) Disconnect the AUO LCD cable
[3]
from the rear of
the LCD panel.
3.) Disconnect and remove the flex board
[4]
by unscrewing the two retaining screws encircled in
.
4.) Disconnect the Inverter Flex Board cable
[2]
from the LCD Backlight Inverter board
[5],
then
disconnect the LCD Back Light Inverter board from the AUO LCD cable
[3]
(arrow at right in
).
5.) Disconnect the Flex Board from the LCD flex
[1]
-
6.) Gently remove the Flex Board and the LCD Back Light Inverter Board.
Figure 8-70 Flex Board and LCD Back Light Inverter Board
Disconnect
here
LCD Backlight
Inverter
Flex Board
2
3
4
5
1