NX-10 Installers manual
207
Term
Definition
Downloading
An
Options
setting option that indicates that downloading is taking place.
E
Event
An alarm condition that has been detected by the control panel.
Event log
A list of events that occur in the system regardless of the armed state of the system. They are held in
a sequential event buffer with a time and date stamp. When the log is full, it overwrites the oldest
entries with new data. These events can later be viewed through downloading.
Events
A
Reporting
menu entry that contains all configurable events for each report control. All events for
report control 1 are enabled by default. Events for all other report controls are disabled by default.
Enabled events are formatted into one or more messages according to pre-configured settings and
sent to the selected report destination.
You must enable
Test Reports
if using the NX-7002 as backup to another auxiliary dialer.
Expander Trouble
and Restores
A
Reporting
setting that sends an expander trouble and restore report to the selected report control.
F
Fail to Communicate
A
Reporting
setting that reports a fail to communicate event to the selected report control.
FTC Report Attempts
A
Reporting
setting that configures the number of attempts that can be made to a specific report
destination before the Fail to Communicate condition is set. This can be from 1 to 15.
G
Good RSSI
An
Options
setting that indicates that the current RSSI level is equal to or greater than the minimum
signal quality level configured in
Line Fault RF Level
. If the RSSI level drops below this value a GSM line
fault is indicated.
GPRS
General Packet Radio Service. A global standard for wireless communications. It supports a range of
bandwidths and can transmit and receive both small bursts and large amounts of data.
An
Options
menu entry that allows a GPRS connection for up/download.
GPRS APN
An
Options
setting that configures the GPRS access point name. Contact the network provider to
obtain this name. This is a mandatory setting if using TCP/IP reporting.
GPRS APN 2
An
Options
setting that configures a second GPRS access point name. Contact the network provider
to obtain this name. This is used if the connection cannot be made via the
GPRS APN
.
GPRS Connected
An
Options
setting that indicates that the module is logged into the GPRS network.
GPRS Disconnect
Delay
This contains the length of time with no activity before the GPRS disconnects.
GSM
Global System for Mobile Communications. A global standard for wireless communications. It
supports narrowband Time Division Multiple Access (TDMA).
An
Options
menu entry that groups GSM connection options.
GSM Connection
An
Options
menu entry that groups GSM connection settings.
GSM Engine Comms
An
Options
setting that indicates that communication with the GSM module is established.
GSM Engine Info
An
Options
menu entry that groups information returned from the on-board GSM module on the GSM
module.
GSM Operator
An
Options
menu entry that groups information on the current GSM operator and allows a specific
GSM operator to be manually selected.
H
Hit 24H Report Limit
An
Options
setting that indicates that the maximum number of reports allowed in 24 hours has been
reached. This applies to SMS and GPRS reports.
