63
10. 10A – instrument illumination, switches, cigarette lighter.
11. 5A – contactor (GAZ32214, 322174).
12. 15A – right clearance light, headlamp aiming device, glovebox lamp.
13. 10A – left clearance light, clearance warning lamp, licence plate lamp.
Note:
Vehicles are provided with the set of spare fuses. A fuse puller is available in the set
of the spare fuses to assist removal of the faulty fuse.
8.9. THERMOSTARTER CONTROL UNIT
(for vehicle with Sofim engine 8140. 43C)
Thermostarter control unit is located on the bracket in the right part of
the front end panel. Depending on the ambient air temperature the control
unit controls the cuttingin of the glow plug and the electromagnetic valve.
8.10. ANTILOCK BRAKE SYSTEM
‘GAZelle” buses are equipped with antilock brake system (ABS) of series
5.3 made by “Bosch”. ABS is effective in case of emergency braking on the roads
with diverse road surface (example: asphaltice) and it prevents locking of the
wheels being in the least favorable road adherence condition (on the ice) en
suring minimum braking distance of the vehicle for this road surface (ice) while
maintaining its stability and steerability. Pulsating vibrations are felt on the
brake pedal during ABS operation.
Attention!
To get the best effect during emergency braking of the vehicle using ABS it is necessary to
press the brake pedal with maximum effort pushing the clutch pedal simultaneously.
The electrical part of the ABS consists of 4 speed sensors located in the
vehicle’s wheel assemblies, hydraulic unit with builtin control unit in the en
gine compartment on the left, ABS failure warning lamp in the instrument clus
ter and ABS
1)
harness.
ABS power circuit is connected directly to vehicle mains via separate 60A
fuse in F41 fuse block and via ignition switch and 10A fuse in F42 fuse block.
The warning lamp lights up for two seconds each time the ignition is
switched on and then goes out. It evidences that ABS system circuits connect
ed to ABS unit are in sound condition. If the warning lamp lights continuous
ly or it lights up during vehicle movement it indicates that ABS circuits went
1)
To determine the beginning of vehicle braking, stop signal switch is used.
