EN
75
FILLING THE WATER TANK
CAUTION
– Only move the water tank vertically, when removing or instal-
ling the water tank, to avoid damage to the valves at the bottom of the water tank
and at the water intake of the appliance.
1. Grasp the water tank at both sides or at the handle under the tank lid und pull it
upwards. Additionally you can open the tank lid for filling the water tank, while
it is still assembled at the rear the appliance. Using this method, ensure that the
water is not spilled.
2. Fill the water tank with clear, cold drinking water. Ensure that the filling level is
between the “MIN” and “MAX” markings. If required, wipe dry the exterior of
the water tank.
3. At the rear of the appliance, slide the water tank vertically down. Close the
water tank lid. When the water tank is installed correctly, the water tank lid
levels up with the top of the appliance. If required, gently press down the water
tank without violence.
EMPTYING THE DRIP TRAY
After each extraction cycle and after using the steam wand, the appliance drains sur-
plus water and water for cooling down the water system automatically into the drip
tray. Therefore, if required, empty the drip tray, before starting a extraction cycle. At
least, when the red filling indicator comes up from under the metal grid, empty the
drip tray to avoid overflow. Additionally, the content of the drip tray may easily be
spilled, when the drip tray is overfilled.
IMPORTANT - When the appliance has been in operation just before, the water
in the drip tray may be hot.
4. Grasp the drip tray at the front and pull it out carefully.
5. Remove the metal grid and empty the drip tray. If required, rinse the drip tray
with clear tap water. Then wipe dry the exterior of the drip tray.
6. Replace the metal grid. The three wide holes in the metal grid must face to the
right front side of the machine. Ensure that the metal grid is lying firmly on the
drip tray. If required, push it down.
7. Slightly push the drip tray into the base of the appliance and ensure that the
drip tray does not protrude the front of the base.
Only operate the appliance,
when the drip tray is installed correctly.
Otherwise, water may run under the
appliance.