90
Electronic Overload Protection
The Multi Juicer will automatically stop operation, if the motor is stalled for more than
10 seconds. Either too much food is being processed at a time or the pieces are
too large or too hard.
Switch off the motor (selection dial to “OFF”, power switch to “O”) and unplug the
appliance. Remove the obstacle. Perhaps, remove some food from the processing
system or cut your food into smaller pieces of even size. Process your food in smal-
ler portions.
Thereafter, you may re-assume operation quite as normally.
Automatic Shut-Off
The appliance is programmed for continuously operating max. 20 minutes. After
approx. 20 minutes in operational mode, the appliance will switch off the motor
automatically, ensuring that the motor is protected from overheating, if you have
forgotten to make a break in time. Another 40 seconds after the automatic shut-off,
even the display will get dark automatically.
If you wish to re-activate the appliance, simply turn the selection dial to another
speed. The motor will start again immediately.
CAUTION:
After an automatic shut-off, the motor will re-start immediately,
when turning the selection dial! This will happen even if the display has been swit-
ched off and is dark. We strongly recommend to switch off the appliance via the
power switch at the rear of the motor base, before turning the selection dial to the
“OFF” position. This way, you avoid that the motor will start with a possibly high
speed, that had been selected before the automatic shut-off has been triggered.
Important:
Although the appliance can be re-activated immediately after the auto-
matic shut-off, we strongly recommend to leave the motor cool down for approx.
20 minutes before re-assuming operation. This holds especially, when working at
high speed levels (4-5), having filled in large amounts and/or pushed hard during
jucing, or processing thick ingredients (heavy load). Applying heavy load for a too
long time is done at the expense of the working life of the motor.
Note
If the motor cannot be re-activated at once, the overheat protection device may
be triggered. In this case, there is no way of starting the motor without leaving the
motor cool down first (see: ‘Self-Resetting Overheat Protection Device’).
