117
JUICING SYSTEM
Problem
Reason
The Solution
The juice collector
does not fit onto the
motor base.
The pulp container is
not placed correctly
at the side of the
motor base.
Place the pulp container onto the pulp container protrusion at
the bottom of the motor base. If positioned correctly, it will fit
closely to the side of the motor base.
Wrong orientation of
the juice collector.
The juice spout of the juice collector must fit into the groove
at the motor base and the pulp guttering must fit into the pulp
container. Position the juice collector accordingly.
The juicing sieve or
any other accessory
is still mounted on
the drive rotor.
Remove any accessories from the drive rotor. The juice collector
is always mounted BEFORE inserting the juicing sieve.
You cannot close
the gap between
juice collector and
juicer cover.
The juicing sieve is
not engaged at the
drive rotor.
Remove the juicer cover. Turn the juicing sieve without pressure
over the drive rotor until the juicing sieve slides down easily.
Then push down the juicing sieve slightly to make it engage
tangibly on the drive rotor.
The pulp container is
not positioned cor-
rectly.
Place the pulp container on the protrusion at the bottom of the
motor base. Otherwise, the pulp spout of the juicer cover cannot
slide into the pulp container.
You cannot fix the
locking arm in its
upper locked posi-
tion.
The juice collector
or juicer cover is not
mounted correctly.
Ensure that the juice collector and juice cover are mounted tight-
ly and without any gaps.
The juicing sieve is
not locked to the
drive rotor correctly.
Remove the juicer cover and turn the juicing sieve to and fro on
the drive rotor until it slides down. Then push the juicing sieve
down gently. It must engage tangibly on the drive rotor. The-
reafter mount the juicer cover again. There may be no gap bet-
ween juicer cover and juice collector. Try again.
