128
3. Ensure that the glass jug is leak-free and the exterior is completely dry. Ensure
that the appliance is switched off at the selection dial and at the power switch.
Then mount the glass jug onto the motor base (see: ‘Blending Runny Food or
Chopping Solid Ingredients’). Then plug in the power plug.
4. Switch on the appliance at the power switch and turn the selection dial several
times on and off to agitate the motor in short pulses. Thereafter leave the appli-
ance operate continuously for another minute at speed level 5.
5. Switch off the appliance at the selection dial and at the power switch. Wait until
the motor stops, then unplug. Remove the glass jug from the motor base (see:
‚Removing the Glass Jugs After Operation’).
6. Pour out the dishwater and rinse the interior of the processing system with clear
water. Check, whether the glass jug and the knives of the blade assembly are
completely clean and no residues of food (e.g. fibres, tendons) are sticking to
the surfaces.
7. Clean the glass jug and lid (including the ingredients cup, or scraper, if required)
in lukewarm dishwater using a soft brush. Then rinse with clear water.
8. Wipe dry all parts and leave dry naturally for approx. 1/2 hour, where the
parts are out of reach of young children.
Tip:
Most residues of food can be removed with this method. If the knives or
sealing surfaces of the glass jug are not clean, you may repeat the above proce-
dure or proceed according to the following section.
THOROUGH CLEANING AND REMOVING STUBBORN RESIDUES
Important:
Only clean the grinding system according to the following instructions.
Do NOT
use any hard or sharp-edged objects for cleaning any parts of the appli-
ance to avoid damage to the surfaces. Scratches in the sealing surfaces may cau-
se leakage.
Note
The mixing and mincing systems may be cleaned via the self-cleaning feature (see
above). Use the instructions in this section, if there are any stubborn residues sti-
cking to the surfaces. Nevertheless, you should perform this procedure regularly
to keep the processing systems hygienically clean and in good operational con-
dition.
1. Empty the glass container completely. Then rinse the glass container thoroughly.
2. Turn the blade assembly counter-clockwise to unscrew it from the glass container.
