126
CLEANING THE JUICING SYSTEM
WARNING:
The knives of the juicing sieve are very sharp.
During clea-
ning, the juicing sieve must be handled with care to avoid injuries and damage
to the fine mesh in the rim of the juicing sieve. For cleaning, it is best to hold the
juicing sieve by the dark drive coupling.
Do NOT use any abrasive cleaners, abrasive cleaning pads, or hard or sharp-
edged objects for cleaning to avoid damage to the surfaces. Do not use violence.
Note
Some types of fruit, spices, or vegetables (e.g. capsicum, carrots, citrus fruit, curcu-
ma) may cause discolouration or leave opaque stains at the transparent plastic
parts. This will not influence the performance of the juicing system. Nevertheless,
you should not leave any food dry on the surfaces. Especially food that could
easily lead to discolouration and stains on the transparent plastic parts should be
removed immediately after processing. Avoid storing the juices or pulp within the
juice jug or pulp container of the appliance to avoid stains.
You may clean the juicer cover, juicing sieve, juice collector, pulp container, and
juice jug in an automatic dishwasher. If possible, select a low temperature and
place the parts in the upper rack.
CAUTION:
The plastic parts may get deformed, when treated with very high
temperature. Do not place any parts of the appliance on hot surfaces.
1. Soak the juicing sieve for approx. 10 minutes in warm dishwater. Then, hold the
juicing sieve by the plastic drive coupling under running tap water and carefully
brush the base and mesh of the juicing sieve clockwise from the centre to the rim
using a soft brush. Hold the juicing sieve up to the light for checking, whether
the pores of the mesh are clean and not clogged by any residues of fibres.
2. For cleaning the juice jug, remove the pouring shield by simply pulling it up and
out.
3. Wash the food pusher, juicer cover, juice collector, pulp container, and the
parts of the juice jug (jug, pouring shield, lid) in warm dishwater using a soft
cloth or a SOFT brush.
4. Rinse all parts with clear tap water. Then wipe dry and leave all parts dry natu-
rally for approx. 1/2 hour, where the parts are out of reach of young children.
