Garmin Approach G5 - GPS-Enabled Golf Handheld, Install Manual & Pilot'S Manual

Page: 60 / 238

Garmin G5 Install Manual & Pilot's Guide 190-02072-00 Rev. E
44
Unit Installation
Installation Manual
Pilot's Guide
Appendix
Index
3) At the same end of the shielded cable and ahead of the previous shield
termination, strip back the jacket and shield from the end of the shielded
cable to a distance between Float Min and Float Max (Table 1-15) to
expose the insulated center conductor(s). If possible, the Ideal Float length
is recommended.
Preferred Method:
Cut the jacket and the shield off at the same point so that no shield is exposed. Slide
a minimum of 0.75 inch of Teflon heat shrink tubing (item 5, Figure 1-23) onto the
cable and use a heat gun to shrink the tubing. The chosen size of heat shrink tubing
must accommodate the number of conductors present in the cable.
Secondary Method :
Leave a maximum 0.35 inch of shield extending past the jacket. Fold this section
of shield back over the jacket. Slide a solder sleeve (item 5, Figure 1-23) over the
end of the cable and use a heat gun approved for solder sleeves to secure the
connection. The chosen size of solder sleeve must accommodate the number of
conductors present in the cable.
4) Strip back approximately 0.17 inch of insulation from each wire of the
shielded cable (item 2, Figure 1-24) and crimp a contact (item 6, Figure
1-24) to each conductor. It is the responsibility of the installer to determine
the proper length of insulation to be removed. The wire must be visible in
the inspection hole after crimping and the insulation must be 1/64 – 1/32
of an inch from the end of the contact as shown in Figure 1-24.