Garmin G5 Install Manual & Pilot's Guide
190-02072-00 Rev. E
88
Unit Installation
Installation Manual
Pilot's Guide
Appendix
Index
7)
After holding the starting position, continue following the on-screen
instructions by slowly turning the aircraft to the right. The dots at the end
of the text will be removed as the aircraft rotates 30º.
8)
Continue following the on-screen instructions until the calibration is
completed. The turn and hold procedure detailed above will repeat for a
total of 12 cycles before the calibration is complete (resulting in the aircraft
completing a full circle of rotation).
9)
If the calibration is successful, a passing status message will be displayed.
The calibration will abort if it cannot be successfully completed. Ensure
all on-screen instruction are followed and repeat the test (if necessary) to
obtain a successful calibration.
1.8.4.6 FLIGHT CONTROLS CONFIGURATION PAGE
Figure 1-59 Flight Controls Configuration Page
1.8.4.6.1 G
eneraL
a
utoPiLot
d
eSCriPtion
The GSA 28 based autopilot system is a fully integrated, high performance autopilot
that can control up to three axes of an aircraft (refer to the G3X Installation Manual
for GSA 28 installation information). Each GSA 28 servo is also capable of managing
the trim control for its axis. The following four subsections (roll, pitch, yaw, and trim)
are provided to aid the pilot/installer in understanding/configuring the Garmin GSA 28
autopilot system.
Summary of Contents for Approach G5 - GPS-Enabled Golf Handheld
