Garmin Approach G5 - GPS-Enabled Golf Handheld, Install Manual & Pilot'S Manual

Page: 157 / 238

Garmin G5 Install Manual & Pilot's Guide 190-02072-00 Rev. E
141
Unit Installation
Installation Manual
Pilot's Guide
Appendix
Index
30 seconds, then reapplying power.
2)
Check that all connectors are fully seated, and that the jack screw
connectors are fully tightened on both sides of all connectors.
3)
Check for a loose wire harness that is able to move around during flight.
This condition may cause the wire to pull on or vibrate the connector,
making intermittent connections.
4)
Ensure that the G5 or any affected LRU is mounted securely. Use the
appropriate tool to check the tightness of all mounting hardware.
5)
Look for any heavy objects that may not be fastened tight to the aircraft
structure that could be inducing vibration in the G5's attitude sensors.
6)
Look for evidence of water or fluid contamination in the area around the
G5 or any affected LRU.
7)
Unplug the connector on the G5 or any affected LRU and check for bent
pins.
8)
Inspect the wire harness clamp on the rear of all connectors to verify that
it is not too tight and smashing/shorting the wires. If the wire clamp is
installed upside down, it has sharp edges that can cut into the wires. Verify
the presence of protective wire wrap between the wires and the clamp.
If the condition is not resolved by following the preceding instructions, contact
Garmin Product Support for additional assistance. A Garmin Field Service Engineer may
ask the technician to email any fault or data logs back to Garmin to help determine if
the condition is caused by a G5, a different LRU, or a source elsewhere in the aircraft
installation.
1.9.2 SD CARD SLOT
A stuck or sticking microSD™ card issue can sometimes be caused by the card
thickness variability (especially if there is more than one label on the card). This is
usually caused by the card sticking in the overlay opening, not by the card sticking
to the socket inside the unit. Try another card (without a label, if possible) to confirm
the problem before returning. If the second card sticks, the microSD™ socket board
inside the unit may be misaligned with the overlay and the G5 will require repair. If
the thickness of the card was the cause, see if more than one label was on the card. If
the labels weren’t the cause, determine what brand of microSD™ card was being used
(Garmin recommends using SanDisk® brand cards).