54
Via Leonardo da Vinci, 32/B
36034 Malo (VI) Italia
Operation and maintenance manual
Rev. 01/18-GB
TZ FIBER 540E / 630E / Conveyor-E
tions. Avoid filling the tank with the engine
running. Avoid smoking or open flames. Do
not overfill the tank. If this happens, wipe im-
mediately.
If necessary, use a funnel to avoid drips. Care-
fully tighten the cap of the tank when the supply
is completed.
• It is not recommended to use the machine
indoors, but, if it was really necessary, before
starting the machine make sure there is ad-
equate ventilation.
Exhaust fumes can kill.
• Before starting, check all the tools, indicators
and warning lights. Check all safety devices
making sure that everything is working prop-
erly.
• Adjust the speed according to the ground
conditions. Watch out for obstacles. Bypass
any rocks and stumps.
• Avoid crossing rails, excavations, crests or
edges. If the crossing cannot be avoided, slow
down and proceed with a certain angle than
the obstacle. Avoid yielding docks, potholes
and steep slopes.
• During operation, the machine can throw
stones and/or blunt objects to a certain dis-
tance. Remove any objects or pets that are
within range of the machine.
• Starting a new dig, move the excavation disc
with extreme caution. The speed of the tool
must be reduced.
At the beginning, the tool will tend to drag the
machine. It is necessary that the operator is
prepared to counter these snags.
• If you leave dropping suddenly the excavation
disc on the ground, this is extremely danger-
ous.
This may cause sudden deviations or displace-
ments of the machine.
• It is recommended to work when the machine
is on the floor, but, if it becomes necessary to
work on slopes, be especially careful about
the possible overturning of the machine.
• Always ensure the stability of the machine.
Vibration can drag the machine to the steep
slope.
• Never try to steer during operation. With the
disc in the ground, any hint of curve should
be dealt with cautiously.
• During the excavation, if the machine hits
something, advances with difficulty or sudden
jams, stop the machine and inspect the inside
of the excavation and the conditions of the
tool.
• IT IS STRICTLY FORBIDDEN TO RELEASE
THE DISC WHILE THE MACHINE IS ON. TURN
OFF THE ENGINE BEFORE REMOVING ANY
OBSTACLES.
Use extreme caution when operating on public
roads open to traffic. It is necessary to keep in
mind the braking capacity of the machine and
adjust accordingly the speed.
• Comply with all signs and regulations in force.
Approach intersections with caution.
Change direction with caution. A too fast turn
can cause the reversal of the machine.
• When finished, always park the machine in an
area used for that function.
Make sure the ground below is stable. Do not
park on soft sand or rough ground.
If possible, park in a plane. Lower the excava-
tion disc and block the tracks.
• In case of failure and if the machine does not
work or you were to leave it temporarily parked,
it is necessary to provide the appropriate
fences, blinkers and danger lights.
4.2.2 START-UP
The start-up of the machine must be on the level
ground and with the disc raised.
CAUTION
During the handling of the machine (even for
short trips), it is mandatory to keep the toothed
disc lifted from the ground (at least 20 cm from
the ground) so as to ensure the stability of the
machine.
You may not start-up the transmitter in places
that do not allow the complete visibility of the
machine operated by the radio control. Activating
the transmitter indoors or however far from the
receiver, you cannot have a real awareness of
