600-SERIES HARDWARE MANUAL
Appendix O - Output Relay Board Help
APPENDIX-Page
5
O.5
Software Setup of the Output Relay board
Note for the SG Software Setup:
After the controllers and the DSI board has been properly added in the software, then
you open the
Serial Channels property
screen (go to Configuration >> Hardware
menu).
Set the DSI ‘s RS-485 channel (port) to operate in ‘General Output or ‘Elevator
Control’ mode (as desired)
and
set the
total number of relays
for that channel (*general
output can have max 24 relays and *elevators can have max 120 relays).
If using general mode, you will set up inputs and outputs as normal. If installing
elevators, set the Elevator Reader’s property to be “checked” for Elevator Reader and
pick the appropriate DSI channel in the droplist on the General tab of the Reader
Property screen.
When you save this, your relays will appear on the Elevator schedules tab of the
Reader Properties screen.