600-SERIES HARDWARE MANUAL
Appendix H - HyperTerminal Commands
APPENDIX-Page H-1
H
– Appendix : Putty/HyperTerminal Commands
A. Connecting to a Terminal Emulator
Connect the programming serial cable to the
J4
serial port of the CPU Board (Rev H or later)
and the standard 9-pin serial (com) port on the PC or laptop that will run Terminal Emulator.
A programming cable comes with the controller enclosure:
•
The cable must have a DB9 female connector on one end and a DB9 male connector on the
other end.
•
Cable Pin-out
must be:
Pin 2 to Pin 2, Pin 3 to Pin 3, Pin 5 to Pin 5.
On the PC/Laptop, click the [START] button.
Browse the menu path to
Programs>Accessories>Communications
and select (click) the
HyperTerminal icon that looks like a telephone.
In the
Connection Description
box you need to type a name for the connection and click [OK]
Terminal Session parameters are:
Bits per Second
=
57,600K
Parity
=
None
Data Bits
=
8
Stop Bits
=
1
Flow Control
=
None
See table of Putty/HyperTerminal commands on next page
Note:
When you close the Terminal, it will prompt you
to save the connection. You can save it and use it in
the future to connect to 600-series & 508i panels.
