8
WARNING
Do not look into a fiber with naked eye during operation. Wearing a
protection glass is recommended.
STOP using the fusion splicer when problems are experienced with
the protection sleeve heater. Turn off the power immediately,
disconnect the power cord, remove the battery, and contact service
center.
Do not use a gas spray to the splicer. The hazardous gas may come
out by electric discharge. It may cause a fire and machine failure.
The NJ001 can be used after following tests:
Drop resistance – 76cm drop from 5 different angles. Water
resistance – IPX2 rating drip proof (exposed to 3mm/min drip for
10 min with 15° tilt). Dust resistance – IP5X rating dust proof
(exposed to dust particles with a diameter of 0.1 to 25µm for 8
hours)
Above tests were performed at Furukawa Electric laboratories and
do not guarantee that the machine will not be damaged when
subjected to these conditions.
CAUTION
Do not place the fusion splicer on an unstable or inclined surface.
There is a possibility that the fusion splicer will fall and cause
injury.
Disconnect all cords when moving the fusion splicer. Failure to do
so may damage the cords which may cause fire or electrical shock.
Do not place the cords around any heating instrument. Doing so
may damage the cords which cause fire or electrical shock.
Do not connect or disconnect cords with wet hands. Doing so may
cause fire or electrical shock.
Do not pull the cord to disconnect. Doing so may damage the cords
which may cause fire or electrical shock. Hold the plug portion and
disconnect the cord.