Fukuda Denshi IB-7300, Service Manual

Page: 145 / 146

Periodic Check List (HC-530)
Periodic Check List
No. .
Item Inspection Method / Criteria Judgment Comment
1. tcp Electrode No damage should be found. OK ／ NG
2. Accessories for Electrode Check storage conditions. OK
／
NG
Cords,
Accessorie
s
3. Operation Manual Must be kept as specified. OK
／
NG
1. Flaws, Cracks, Deformation and
Rust
Must be free from damage.
OK
／
NG
2. Panel and Label
Must not be damaged,
scratched or erased.
OK
／
NG
Ap
p
earan
c
e
Appearanc
e
3. Key, LED and Other Must be free from damage. OK
／
NG
1. Key Must operate property.
OK
／
NG
Module
2. Input Connector Must perform normally.
OK
／
NG
Mech
an
ica
l
Installation
into the
Input Box
1. Lock Must perform normally.
OK
／
NG
1. CAL LED
Must light when the cable is
connected and electrode is
attached to the socket.
OK ／ NG
2. Calibration
The calibration must be
properly performed by pressing
the CAL key on the HC-530.
OK
／
NG
3. Electrode Attachment Time
After calibration, remove the
electrode from the socket and
set the electrode site time to 30
min. “SITE TIME OVER”
must be displayed when 30
minutes have elapsed.
OK
／
NG
4. Electrode Heating Control
The accuracy must be within
± 0.1
°
C.
OK
／
NG
Electrical
Function
5. Cable Detection
The data must disappear when
the cable is unplugged.
OK
／
NG
1. Enclosure Leakage Current (N.C.) Less than 0.1mA OK
／
NG
2. Enclosure Leakage Current
(S.F.C.)
Less than 0.5mA
OK
／
NG
3. Patient Leakage Current I (N.C.) Less than 0.01mA OK
／
NG
4. Patient Leakage Current I (S.F.C.) Less than 0.05mA OK
／
NG
Leakage
Current
5. Patient Leakage Current III (S.F.C.) Less than 0.05mA OK
／
NG
1. Between Isolated Applied Part and
Primary
AC 4kV/1min
OK ／ NG
Safety
Withstandi
ng Voltage 2. Between Isolated Applied Part and
Enclosure
AC 1.5kV/1min
OK ／ NG
Overall
Judgment
OK
／
NG
Equipment
tcpO
2
/pCO
2
Module
Model
Type
HC-530
Serial
Number
Installation
Place Date of
Purchase
Date of
Inspection
Inspector Approval
10
－
26