Fukuda Denshi IB-7300, Service Manual

Page: 109 / 146

DIP Switch/Rotary Switch Setup
In this section, the settings of DIP switch and rotary switch are explained.
The DIP switch and rotary switch are located inside the maintenance cover (7-segment LED cover)
on the back of the main unit.
Rotary Switch DIP Switch
IB-7300 DIP Switch Setup
SW No. Default Description (When ON)
1 OFF Not used. (Reserved function)
2 OFF Not used. (Reserved function)
3 OFF Not used. (Reserved function)
4 OFF Not used. (Reserved function)
5 ON Power failure buzzer OFF
6 OFF Forced powering
7 OFF Not used. (Reserved function)
8 OFF
Enforced installing of application software and writing of
EEPROM data
1
：
This is the mode for factory inspection, and should not be used during normal operation.
8
：
Used only for installing the software/EEPROM. Prevents unintended installing. Normally
the setting is OFF.
IB-7300 Rotary Switch Setup
SW No. Default Description
0
○
Normal operation mode
1
～
6 Not used.
7 Used only for factory adjustment.
8
～
B
Not used.
C
Equipment test mode
D
Not used.
E
Reserved
F Initialize internal setup to factory default setup. (Initialize)
0
：
Normally, set the rotary switch to “0”.
7
：
Used for factory adjustment.
If this mode is entered without adjustment information/facility, and the equipment setup is
changed, the equipment may become unusable. Do not use this mode outside factory.
C
：
Communication test is performed.
F
：
When the power is turned ON with this mode, the user settings will be initialized.
C A U T I O N
Be sure to replace the cover after adjusting the settings to prevent the user
from being able to change the settings easily.
9
－
2