Fujitsu PRIMERGY TX300 S7, Upgrade And Maintenance Manual, Page: 897 / 898

TX300 S7 / RX350 S7
Upgrade and Maintenance Manual 897
Appendix
17.4 Minimum startup configuration
If the server does not start up or other problems occur, it may be necessary to
take the system down to its most basic configuration in order to isolate the
defective component.
The minimum startup configuration consists of the following components and
cables:
Ê
Shut down the server as described in section "Shutting down the server" on
page 67 .
Ê
Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
"Disconnecting the server
from the mains" on page 68 .
Field Replaceable Units (FRU)
Component Notes and reference
System board no TPM, UFM or expansion cards installed
1 CPU with CPU heat sink
installed in socket CPU 1, see section
"Installing processors" on page 551
1 memory module
installed in DIMM slot 1A, see section
"Memory sequence" on page 530
Front panel module without connected front LAN module
1 Power supply module
installed in PSU slot 1, see section "Installing
PSU modules" on page 167
Table 7: Minimum startup configuration - components
Cable Notes and reference
Front panel cable
see section "Replacing the front panel
module" on page 700
Power cable
see section "Replacing the power backplane"
on page 179
Table 8: Minimum startup configuration - cables