Fujitsu PRIMERGY TX300 S7, Upgrade And Maintenance Manual, Page: 273 / 898

TX300 S7 / RX350 S7
Upgrade and Maintenance Manual 273
Hard disk drives / solid state drives
Only applicable for removing intact HDD modules:
Ê
Before removing a non-defective HDD module, put the drive into "Offline"
mode using your RAID configuration software.
I
For further information, please refer to the "ServerView Suite RAID
Management" user guide, available online at
http://manuals.ts.fujitsu.com
( http://jp.fujitsu.com/platform/server/primergy/manual/ for the Japanese
market) or from the ServerView Suite DVD 2 supplied with your
PRIMERGY server.
7.3.8.3 Removing a 3.5-inch HDD module
Ê
Remove the HDD module to be replaced from the server as described in
section
"Removing a 3.5-inch HDD module" on page 269 .
7.3.8.4 Installing a 3.5-inch HDD module
Ê
Install the new HDD module into the empty drive bay as described in section
"Installing 3.5-inch HDD modules" on page 262 .
7.3.8.5 Concluding steps
Perform the following procedures to complete the task:
Ê
When working on a tower server, close the HDD bay cover as described in
section
"Installing accessible drive and HDD bay covers" on page 111 .
Ê
Please observe the notes on RAID rebuild in section "Performing a RAID
array rebuild" on page 157 .