Fujitsu PRIMERGY TX300 S7, Upgrade And Maintenance Manual, Page: 356 / 898

356 Upgrade and Maintenance Manual
TX300 S7 / RX350 S7
Hard disk drives / solid state drives
7.4.10 Replacing the 8x 2.5-inch HDD extension box
7.4.10.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Installing the HDD extension box: tool-less
7.4.10.2 Preliminary steps
Before removing the HDD extension box, perform the following steps:
Ê
Shut down the server as described in section "Shutting down the server" on
page 67 .
Ê
Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
"Disconnecting the server
from the mains" on page 68 .
Ê
When working on a rack-mounted server, extend it out of the rack as
described in section
"Extending the server out of the rack" on page 72 .
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 73 .
Ê
Open the side / top cover as described in section "Removing the top cover"
on page 75 (rack server) or "Removing the side cover" on page 84 (tower
server).
Ê
Remove all HDD modules from the HDD extension box as described in
section
"Removing 2.5-inch HDD / SSD modules" on page 211 .
Ê
Pull out the ID card and open the front cover as described in section
"Opening the server" on page 75 .
Ê
Remove the air duct as described in section "Removing the system air duct"
on page 92 .
Ê
Remove the system fan holder as described in section "Removing the
system fan holder" on page 378 .
Upgrade and Repair Units (URU)
Average task duration: 10 minutes