Fujitsu PRIMERGY TX300 S7, Upgrade And Maintenance Manual, Page: 690 / 898

690 Upgrade and Maintenance Manual
TX300 S7 / RX350 S7
Accessible drives
12.7.2.2 Preliminary steps
Before removing a slimline ODD, perform the following steps:
Ê
Remove all backup and optical disk media from backup and optical disk
drives as described in section
"Removing backup and optical disk media" on
page 136 .
Ê
Shut down the server as described in section "Shutting down the server" on
page 67 .
Ê
Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
"Disconnecting the server
from the mains" on page 68 .
Ê
When working on a rack-mounted server, extend it out of the rack as
described in section
"Extending the server out of the rack" on page 72 .
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 73 .
Ê
Open the side / top cover as described in section "Removing the top cover"
on page 75 (rack server) or "Removing the side cover" on page 84 (tower
server).
Ê
Pull out the ID card and open the front cover as described in section
"Opening the server" on page 75 .
I
The front cover only needs to be removed in order to install
accessible drive dummy covers (see section
"Installing accessible
drive dummy covers" on page 622 ). If the HDD extension box will be
reinstalled after removing the slimline ODD, skip this step.
Ê
Remove the air duct as described in section "Removing the system air duct"
on page 92 .
Ê
Remove the system fan holder as described in section "Removing the
system fan holder" on page 378 .
12.7.2.3 Removing the 4x 3.5-inch HDD extension box
Ê
Remove the 4x 3.5-inch HDD extension box from installation bays 1, 2 and
3 as described in section
"Removing the 4x 3.5-inch HDD extension box" on
page 331 .