Fujitsu PRIMERGY TX2550 M5, Upgrade And Maintenance Manual

Page: 117 / 636

When the enabled expansion card is initialized during the POST phase of the
boot sequence, a key combination is displayed temporarily to enter the
firmware of the expansion card.
▶
Press the displayed key combination.
▶
Modify the expansion card firmware options as desired.
▶
Save your changes and exit the firmware.
The option ROM of the expansion card can now be disabled in the
BIOS.
Exception: If the expansion card controls a permanent boot device, the
Option ROM of the expansion card has to remain enabled.
5.3.5 Reconfiguring the backup software solution
This task only applies to Japan.
Disabling backup drives
Depending on the backup software solution, it may be necessary to disable or
delete the backup drive from the backup software drive list and reconfigure
backup jobs after completing the maintenance task.
More information on suitable backup software solutions and related
documentation is available from the Fujitsu web pages.
Re-enabling backup drives
If a backup drive has been disabled or deleted from the backup software drive
list (see
"Verifying and configuring the backup software solution" on page 110 ),
it has to be re-enabled to complete the maintenance task.
▶
Re-enable backup drives and revise backup software settings and cronjobs.
More information on suitable backup software solutions and related
documentation is available from the Fujitsu web pages.
Basic software procedures
TX2550 M5 Upgrade and Maintenance Manual 117