Fujitsu PRIMERGY TX2550 M5, Upgrade And Maintenance Manual

Page: 519 / 636

▶
Connect all cables to the system board:
▶
Front panel cable
▶
Front USB cable
▶
Power cable(s) for HDD backplane(s)
▶
SATA cable(s) for HDD backplane(s)
▶
SATA cable for ODD (if applicable)
Run the SATA ODD as shown in Figure 287 .
▶
Power cable for ODD (if applicable)
▶
OOB cable (if applicable)
Concluding steps
▶
If applicable, install the M.2 SSD, see "Installing an M.2 SSD" on page 492 .
Use the screws removed before.
▶
If applicable, install the iRMC microSD card, see "Installing the iRMC
microSD card" on page 488 .
▶
If applicable, install the TPM, see "Installing the TPM" on page 476 .
▶
If applicable, install the OCP module, see "Installing the OCP module" on
page 340 .
▶
Install the memory modules, see "Installing memory modules" on page 401 .
Ensure that you install each memory module in the slot it was located
before the replacement.
CAUTION
In case of NVM/LRDIMMs are not reinstalled in the right slots, data can
be lost!
▶
Install all expansion cards, see "Expansion cards and backup units" on
page 323 .
▶
Install the fan bridge, see "Handling the fan bridge" on page 92 .
▶
"Installing the crossbar" on page 91 .
System board and components
TX2550 M5 Upgrade and Maintenance Manual 519